Introduction

The Alde control panel allows you to manage the heating and hot water system in your nuCamp RV. This guide will walk you through the settings and functions of the Alde control panel.



Getting Started with the Alde Control Panel

1. Standby Screen Overview

  • Displays the indoor temperature using an internal probe sensor.
  • Circulation pump icon: Indicates operation.
  • Shore power icon: Confirms connection.

2. Setting Your Desired Temperature

  • Main menu: Set the indoor temperature.
  • Does not read outdoor temperature (no external probe sensor).

3. Adjusting Hot Water Settings

  • Normal Mode: Regular hot water and heating operation.
  • Boost Mode: Provides extra hot water for 30 minutes, then reverts to normal.
  • Recommendation: Turn on Boost Mode before showering.

4. Selecting Power Source

  • 1 kW → Use when plugged into a 15-amp outlet (half power to prevent overloading).
  • 2 kW → Use when connected to a 20 or 30-amp outlet (full power).
  • Propane Mode → Turn off electric and turn on propane.
  • Electric Mode → Turn off propane and turn on electric.

5. Setting Priorities for Power Source

  • If both propane and electric are available, set the default power source:
    • Electric priority: Uses shore power first (recommended to save propane).
    • Propane priority: Uses propane first if preferred.

Advanced Settings

6. Night Mode & Day Mode

  • Allows automatic heating control based on schedule.
  • Set specific timeframes for the heat to turn on or off.
  • Example Use: If you are out for a hike or skiing, program the heat to turn on before you return.
  • If heating is not working, check if these modes are activated.

7. Adjusting Units & Display Settings

  • Temperature Units: Choose between Celsius or Fahrenheit.
  • Display Brightness: Adjust screen brightness.
  • Sound Settings: Enable or disable button sounds.

8. Automatic Temperature Increase (Legionella Prevention)

  • Runs at 2:00 AM to increase hot water temperature and prevent bacteria growth.

9. Temperature Offset Calibration

  • If the Alde temperature reading is inaccurate:
    • Adjust up or down by 5 degrees max to match an external thermometer.

10. Delayed Start Mode

  • Allows the heating system to start automatically at a later time.
  • Can be set for one cycle per week.
  • Example: Set from 12:00 AM Monday to 10:00 AM Tuesday, and it will repeat weekly.

11. Pump Settings

  • THM Mode (default): Regular operation.
  • Continuous Mode: Used only for servicing (leave off unless instructed).

12. Reset & Factory Settings

  • Reset Option: Restores factory settings.
  • External Switch: Not used in nuCamp models.

13. Service Mode (Troubleshooting Information)

  • Displays glycol temp, water temp, and fan rotation.
  • If troubleshooting, tech support may ask for these values.
  • Typical Water Temperature:
    • 120-130°F (15-amp outlet)
    • 150°F+ (propane or 30-amp service)

14. Installed Accessories

  • Lists features installed in the RV.
  • Do not manually check/uncheck items; contact nuCamp for assistance.

Conclusion

This guide covers the key settings and functions of the Alde control panel in nuCamp RVs. For additional support, contact tech@nucamprv.com. 


Thank you and enjoy your travels!