Introduction

This video can be applied to the 2023, 2024, and 2025 TAG or TAG XL.

Winterizing your nuCamp TAG protects your water system from freezing temperatures. Follow these steps to ensure your camper is properly prepared for winter storage.

1. Locate Key Components

• On the driver’s sideof the TAG, identify the following:
  • City water inlet
  • Fresh tank fill inlet
  • External shower connection

2. Drain the Freshwater Tank

• Open the freshwater tank drain to allow water to exit the system.

3. Prepare the Water Pump for Antifreeze

• Under the sink, unthread the hose on the inlet side of the water pump.
• You will need a fitting adapter to connect the hose to the inlet 
• Place the other end of the hose into the antifreeze container.

4. Siphon Antifreeze into the System

• Turn on the water pump to begin siphoning antifreeze into the system.
• Open the water faucet and run antifreeze through the faucet until pink liquid is visible.

5. Winterize the External Shower

• Open the external shower and connect the hose.
• Run antifreeze through the external shower hose.
• Turn off the water pump.
• Disconnect the external shower hose by pushing back the collar of the connection.
• Drain any excess antifreeze from the hose before storing it.

6. Remove Excess Antifreeze and Reconnect the System

• Place a towel or rag inside the cabinet to catch any antifreeze leaks.
• Remove the hose from the antifreeze container.
• Hold the hose over a bucket to prevent antifreeze from spilling onto the ground.
• Remove the other end of the hose from the water pump.
• Reconnect the fresh tank hose to the water pump.

7. Final Cleanup and Tightening

• Use a towel to clean up any excess antifreeze.
• Use a wrench to tighten the plumbing connections with a quarter turn.

Final Step: Ready for Winter Storage

Your nuCamp TAG is now properly winterized! If you have any questions, email tech@nucamprv.com.

Stay warm and safe!