1. Locate the white ground wire coming from the Alde heating system that runs to the ground bar found underneath the bench seat on the driver’s side of the Unit.


2. Disconnect the ground wire from the ground bar/bus bar and add another white wire to that ground wire that is the same gauge.


3. Look for the copper ground wire that runs through the floor – that is where you will drill to run your extended ground wire through floor to the battery.


4. After you have run your wire through the floor, run it to the negative terminal on the battery.



Note: This should alleviate fuses being blown by the Alde itself. You can still blow fuses but failing to turn the Alde touch screen control Panel OFF before you unplug/plug in the unit or turn the battery on/off.